Inspect the created patient model

This last page of the wizard allows you to check whether the patient model is correct. Do one of the following:

—     To accept the patient model, click Finish.

—     To adjust the patient model, go back to the previous step by clicking Back.

Note

Modifying the created model afterwards is possible using the Edit Patient action.

I do not see the correct model. How can I resolve this?

When something is wrong with the generated model, for example when there is too much noise, or when a specific part of the model is hampering a clear view on the part you actually need to see, you can resolve this by taking the following steps, preferably in this order:

1.       Inspect the volume of interest. Make sure no redundant parts are included, and cut off as much as possible without losing relevant and important information.

2.     Adjust the isovalue when necessary.

3.     Adjust the model using the Patient Mask.