Exporting to DTX Studio Implant
Make sure a connection with the implant module (DTX Studio™ Implant) has been established in the settings.
To launch DTX Studio Implant:
Select the patient record in the 
patient list.
Notes
At least one 3D X-ray must be available for this patient.
DTX Studio Implant 3.4 or a later version needs to be installed on your computer.
If teeth have been virtually added or extracted in DTX Studio Clinic, the altered IO scan will be exported as main scan, and the original IO scan will be set as diagnostic scan.
Click 
Implant.
If the patient record has not been exported before, click 
Export to new patient. Otherwise, click 
Open existing patient and DTX Studio Implant will be launched.
If there is more than one 3D X-ray, select the appropriate tile.
Notes
The most recent 3D X-ray is selected by default.
Click Export.
DTX Studio Implant is opened and/or a patient record is created in DTX Studio Implant.
Note
Patient data needs to be added manually to the patient record in DTX Studio Implant in the following cases:
the patient record already exists in DTX Studio Implant.
intraoral scans are exported to DTX Studio Implant but are not aligned with the 3D X-ray.
See DTX Studio Implant settings to set the export location for these patient data.