on the Plan tab.To add an implant to the treatment plan:
1. Click Implant on the Plan tab.
2. Click the model to indicate the implant shoulder point.
3. Click the model to indicate the apex of the implant.
Note
It is most convenient to define these points on an appropriate 2D reslice.
4. The Product Selection window is shown.
5. Select an implant:
— Select the appropriate manufacturer in the Manufacturer section.
Note
Manufacturers which are available on the server for download but which are not installed, are displayed in a disabled status (gray).
— If necessary, narrow down the implant product types using the filter in the Implant products section.
— Indicate the implant product type.
— Choose the appropriate implant properties in the details pane.
6. Optionally, select a compatible standard abutment from the section with the same name.
7. Verify the estimated tooth position assigned by the system. If necessary, adjust the position by clicking the appropriate tooth in the tooth chart.
8. Click Select Product to confirm your choice or Cancel to discard.
9. Set the surgery type for each planned implant individually.