in the Communicate group on the Finalize tab of the Planning module.To create a report:
1. Ensure that a patient file is opened. Click Report in the Communicate group on the Finalize tab of the Planning module.
2. The list of planning files is shown. Select the appropriate treatment plan and click Next. The system loads the data and generates the report pages.
3. Give the report an appropriate name.
4. Optionally, add a note (up to 700 characters) to the report.
5. Preview images of the report pages are displayed and include an overview of the available general information in the patient file, treatment, the scanner used, the planning warnings, and products used, as well as images of the surgical planning. The preview images are generated with a lower resolution than the actual pdf file. Customize the report by selecting the pages to be included: click the pages you want to remove from the report. The deselected pages are displayed in gray and will not be included in the final report.
6. If necessary, make the report anonymous.
7. Click Finish to create the report or Cancel to discard the request.
8. Upon confirmation, a pdf file is shown displaying the selected pages for the report. Scroll through the pages to check them.
Note
If the wrong jaw type was selected in the Create Patient wizard, this may result in an incorrect visualization or orientation of the patient model in the reports. Therefore, if the planning overview in the report shows the patient model in the wrong direction, correct it in the Edit Patient wizard.