To disable communication with USB image sensor devices:
Open the Settings dialog.
Click Devices.
By default, USB image sensor support is selected. Clear this check box to disable sensor support. Disabling sensor support will block communication with the USB image sensors.
To add a TWAIN-supported device to DTX Studio Clinic for Windows, make sure that the third-party TWAIN software is installed. Otherwise, you will not be able to add the TWAIN device.
Open the Settings dialog.
Click Devices.
Click Add.
Select the TWAIN device.
Configure the device settings.
Click Add.
To add images from third-party camera devices or third-party (CB)CT devices, set up a direct folder in which new images will be detected. Add them with the Capture action.
Prepare your camera device settings:
If possible, set up your third-party camera device, (CB)CT device or wireless SD card to store images in a specific folder.
If the images are stored on a standard SD card, insert it and take note of the assigned drive letter.
Open the Settings dialog.
Click Devices.
Click Add.
Select the third-party device and click Select.
Click Browse to select the camera device folder and click Select folder.
Enter a specific name.
Change the modality and folder properties, if needed.
Click Add.