Trim a Skin Model
Use the trim functionality to remove unnecessary model artefacts and regions. This improves the visual representation in the Diagnose overview.
On the last page of the Create skin model, click 
Trim.
Note
All parts of the model underneath the indicated region are erased, so make sure you tilt the model in the right angle before you start trimming.
Use the Brush size slider to set the brush size.
To trim a single region, click it.
To trim large regions at once: click, hold down the mouse button and drag over the areas that you want to trim. Hold down the shift key simultaneously to trim straight lines.
Undo or redo a trim action by clicking 
or 
. Alternatively, press [Ctrl+Z] or [Cmd+Z] to undo, and [Ctrl+Y] or [Cmd+Y] to redo.